New discoveries made about a promising solar cell material, thanks to new microscope

23-Nov-2022 - USA

A team of scientists from the Department of Energy’s Ames National Laboratory developed a new characterization tool that allowed them to gain unique insight into a possible alternative material for solar cells. Under the leadership of Jigang Wang, senior scientist from Ames Lab, the team developed a microscope that uses terahertz waves to collect data on material samples. The team then used their microscope to explore Methylammonium Lead Iodide (MAPbI3) perovskite, a material that could potentially replace silicon in solar cells.

U. S. Department of Energy Ames National Lab

Visualization of the microscope tip exposing material to terahertz light. The colors on the material represent the light-scattering data, and the red and blue lines represent the terahertz waves.

Richard Kim, a scientist from Ames Lab, explained the two features that make the new scanning probe microscope unique. First, the microscope uses the terahertz range of electromagnetic frequencies to collect data on materials. This range is far below the visible light spectrum, falling between the infrared and microwave frequencies. Secondly, the terahertz light is shined through a sharp metallic tip that enhances the microscope’s capabilities toward nanometer length scales.

“Normally if you have a light wave, you cannot see things smaller than the wavelength of the light you're using. And for this terahertz light, the wavelength is about a millimeter, so it’s quite large,” explained Kim. “But here we used this sharp metallic tip with an apex that is sharpened to a 20-nanometer radius curvature, and this acts as our antenna to see things smaller than the wavelength that we were using.”

Using this new microscope, the team investigated a perovskite material, MAPbI3, that has recently become of interest to scientists as an alternative to silicon in solar cells. Perovskites are a special type of semiconductor that transports an electric charge when it is exposed to visible light. The main challenge to using MAPbI3 in solar cells is that it degrades easily when exposed to elements like heat and moisture.

According to Wang and Kim, the team expected MAPbI3 to behave like an insulator when they exposed it to the terahertz light. Since the data collected on a sample is a reading of how the light scatters when the material is exposed to the terahertz waves, they expected a consistent low-level of light-scatter throughout the material. What they found, however, was that there was a lot of variation in light scattering along the boundary between the grains.

Kim explained that conductive materials, like metals, would have a high-level of light scattering while less-conductive materials, like insulators, would not have as much. The wide variation of light scattering detected along the grain boundaries in MAPbI3 sheds light on the material’s degradation problem.

Over the course of a week, the team continued to collect data on the material, and data collected in that time showed the degradation process through changes in the levels of light scatterings. This information can be useful for improving and manipulating the material in the future.

“We believe that the present study demonstrates a powerful microscopy tool to visualize, understand and potentially mitigate grain boundary degradation, defect traps, and materials degradation,” said Wang. “Better understanding of these issues may enable developing highly efficient perovskite-based photovoltaic devices for many years to come."

Original publication

Other news from the department science

These products might interest you

DM8000 M & DM12000 M

DM8000 M & DM12000 M by Leica

See More, Detect Faster

High-throughput Inspection Systems

Optische Inspektionssysteme
DM6 M

DM6 M by Leica

Upright Material Microscope

All Set and remembered

microscopes
alpha300 R

alpha300 R by WITec

3D Raman microscopes with unequalled speed, sensitivity and resolution

Visualize and characterize every chemical detail

Raman microscopes
LUMOS II

LUMOS II by Bruker

FT-IR microscopy in the fast lane - the LUMOS II

One infrared microscope for all

FT-IR microscopes
HYPERION II

HYPERION II by Bruker

FT-IR and IR laser imaging (QCL) microscope for research and development

Analyze macroscopic samples with microscopic resolution (5 µm) in seconds

FT-IR microscopes
ZEISS ZEN core

ZEISS ZEN core by Carl Zeiss

ZEISS ZEN core - Your Software suite for connected microscopy in laboratory and production

The comprehensive solution for imaging, segmentation, data storage and analysis

microscopy software
Loading...

Most read news

More news from our other portals

All FT-IR spectrometer manufacturers at a glance