Sheffield plate

Sheffield plate is a layered combination of silver and copper that was used for many years to produce a wide range of household articles. These included buttons, caddy spoons, serving utensils, candlesticks and other lighting devices, tea and coffee services, serving dishes and trays, tankards and pitchers, and larger items such as soup tureens and hot-water urns. Almost every article made in sterling silver was also crafted by Sheffield makers, who used this manufacturing process to produce nearly identical wares at far less cost.

Additional recommended knowledge

Better weighing performance in 6 easy steps

Daily Visual Balance Check

Essential Laboratory Skills Guide

Sterling silver alone would have been far too expensive for the emerging middle classes to afford, so there was a continual search in mid-18th century England for a suitable replacement. Thomas Boulsover, of Sheffield's Cutlers Company, provided the solution in 1743. While trying to repair the handle of a customer's decorative knife, he heated it too much and the silver started to melt. When he examined the damaged handle, he noticed that the silver and copper had fused together very strongly. Experiments showed that the two metals behaved as one when he tried to reshape them, even though he could clearly see two different layers.

Boulsover set up in business, funded by Strelley Pegge of Beauchief, and carried out further experiments in which he put a thin sheet of silver on a thick ingot of copper and heated the two together to fuse them. When the composite block was hammered or rolled to make it thinner, the two metals were reduced in thickness at similar rates. Using this method, Boulsover was able to make sheets of metal which had a thin layer of silver on the top surface and a thick layer of copper underneath. When this new material was used to make buttons, they looked and behaved like silver buttons but were a fraction of the cost.

The "double sandwich" form of Sheffield plate was developed around 1770. Used for pieces such as bowls and mugs that had a visible interior, it consisted of a sheet of silver each side of a piece of copper; early manufacturers applied a film of solder over the bare edge of copper although such pieces are very rare. Later on, borders were applied with a U-shaped section of silver wire to conceal the copper which can be felt as a lip on the underside.

Following the invention of German silver, around 1820, it was found that this new material also fused well with sheet silver and provided a suitable base metal for the Sheffield process. Because of its nearly silver color, German silver also revealed less wear, or "bleeding", when Sheffield-made articles were subject to daily use and polishing. Being much harder than copper, it was used from the mid-1830s but only for articles such as trays or cylindrical items that didn't require complex shaping.

Sheffield plate is fairly rare today, as after about 1840 it was generally replaced with electroplating processes, such as that of George Elkington. Electroplating tends to produce a "brilliant" surface with a hard color as it consists of pure rather than sterling silver and it is usually deposited far more thinly. Sheffield plate continued to be used for up to a further 100 years for silver plated articles subject to heavy wear, most commonly uniform buttons and tankards. During the 1840-50 period hybrid articles such as sugar bowls were produced with the body being Old Sheffield and complicated small parts such as the feet and handles made from electroplate. These are rare and seldom recognised.

Much Old Sheffield seen today has been electroplated, especially items which received much use and polishing such as candlesticks. Collectors should also be aware that many designs have been reproduced in electroplate, with those from the early 1900s being the hardest to recognise since, like the original items, they seldom have a makers mark. The way to recognise the genuine article is to realise and look for signs that it was soldered from pre-plated metal parts rather than made in base metal and plated afterwards. Look carefully for soldered joints, often well disguised by the expert makers of the time.

See also

• Plated ware
• Electroplating

References

• Encyclopaedia Britannica 1911: "sheffield plate"