Ferromagnetism

  Ferromagnetism is the "normal" form of magnetism with which most people are familiar, as exhibited in horseshoe magnets and refrigerator magnets. It is responsible for most of the magnetic behavior encountered in everyday life. The attraction between a magnet and ferromagnetic material is "the quality of magnetism first apparent to the ancient world, and to us today," according to a classic text on ferromagnetism.^[1]

Ferromagnetism is defined as the phenomenon by which materials, such as iron, in an external magnetic field become magnetized and remain magnetized for a period after the material is no longer in the field.

All permanent magnets are either ferromagnetic or ferrimagnetic, as are the metals that are noticeably attracted to them.

Historically, the term ferromagnet was used for any material that could exhibit spontaneous magnetization: a net magnetic moment in the absence of an external magnetic field. This general definition is still in common use. More recently, however, different classes of spontaneous magnetisation have been identified when there is more than one magnetic ion per primitive cell of the material, leading to a stricter definition of "ferromagnetism" that is often used to distinguish it from ferrimagnetism. In particular, a material is "ferromagnetic" in this narrower sense only if all of its magnetic ions add a positive contribution to the net magnetization. If some of the magnetic ions subtract from the net magnetization (if they are partially anti-aligned), then the material is "ferrimagnetic". If the ions anti-align completely so as to have zero net magnetization, despite the magnetic ordering, then it is an antiferromagnet. All of these alignment effects only occur at temperatures below a certain critical temperature, called the Curie temperature (for ferromagnets and ferrimagnets) or the Néel temperature (for antiferromagnets).

Additional recommended knowledge

Daily Visual Balance Check

Daily Sensitivity Test

Recognize and detect the effects of electrostatic charges on your balance

Ferromagnetic materials

Main article:

There are a number of crystalline materials that exhibit ferromagnetism (or ferrimagnetism). The table on the right lists a representative selection of them here, along with their Curie temperatures, the temperature above which they cease to exhibit spontaneous magnetization (see below).

Ferromagnetic metal alloys whose constituents are not themselves ferromagnetic in their pure forms are called Heusler alloys, named after Fritz Heusler.

One can also make amorphous (non-crystalline) ferromagnetic metallic alloys by very rapid quenching (cooling) of a liquid alloy. These have the advantage that their properties are nearly isotropic (not aligned along a crystal axis); this results in low coercivity, low hysteresis loss, high permeability, and high electrical resistivity. A typical such material is a transition metal-metalloid alloy, made from about 80% transition metal (usually Fe, Co, or Ni) and a metalloid component (B, C, Si, P, or Al) that lowers the melting point.

A relatively new class of exceptionally strong ferromagnetic materials are the rare-earth magnets. They contain lanthanide elements that are known for their ability to carry large magnetic moments in well-localized f-orbitals.

Physical origin

The property of ferromagnetism is due to the direct influence of two effects from quantum mechanics: spin and the Pauli exclusion principle.

The spin of an electron, combined with its orbital angular momentum, results in a magnetic dipole moment and creates a magnetic field. (The classical analogue of quantum-mechanical spin is a spinning ball of charge, but the quantum version has distinct differences, such as the fact that it has discrete up/down states that are not described by a vector; similarly for "orbital" motion, whose classical analogue is a current loop.) In many materials (specifically, those with a filled electron shell), however, the total dipole moment of all the electrons is zero (i.e., the spins are in up/down pairs). Only atoms with partially filled shells (i.e., unpaired spins) can experience a net magnetic moment in the absence of an external field. A ferromagnetic material has many such electrons, and if they are aligned they create a measurable macroscopic field.

These permanent dipoles (often called simply "spins" even though they also generally include orbital angular momentum) tend to align in parallel to an external magnetic field, an effect called paramagnetism. (A related but much weaker effect is diamagnetism, due to the orbital motion induced by an external field, resulting in a dipole moment opposite to the applied field.) Ferromagnetism involves an additional phenomenon, however: the dipoles tend to align spontaneously, without any applied field. This is a purely quantum-mechanical effect.

According to classical electromagnetism, two nearby magnetic dipoles will tend to align in opposite directions (which would create an antiferromagnetic material). In a ferromagnet, however, they tend to align in the same direction because of the Pauli principle: two electrons with the same spin cannot also have the same "position", which effectively reduces the energy of their electrostatic interaction compared to electrons with opposite spin. (Mathematically, this is expressed more precisely in terms of the spin-statistics theorem: because electrons are fermions with half-integer spin, their wave functions are antisymmetric under interchange of particle positions. This can be seen in, for example, the Hartree-Fock approximation to lead to a reduction in the electrostatic potential energy.) This difference in energy is called the exchange energy.

At long distances (after many thousands of ions), the exchange energy advantage is overtaken by the classical tendency of dipoles to anti-align. This is why, in an equilibriated (non-magnetized) ferromagnetic material, the dipoles in the whole material are not aligned. Rather, they organize into magnetic domains (also known as Weiss domains) that are aligned (magnetized) at short range, but at long range adjacent domains are anti-aligned. The transition between two domains, where the magnetization flips, is called a domain wall (i.e., a Bloch/Néel wall, depending upon whether the magnetization rotates parallel/perpendicular to the domain interface) and is a gradual transition on the atomic scale (covering a distance of about 300 ions for iron).

Thus, an ordinary piece of iron generally has little or no net magnetic moment. However, if it is placed in a strong enough external magnetic field, the domains will re-orient in parallel with that field, and will remain re-oriented when the field is turned off, thus creating a "permanent" magnet. This magnetization as a function of the external field is described by a hysteresis curve. Although this state of aligned domains is not a minimal-energy configuration, it is extremely stable and has been observed to persist for millions of years in seafloor magnetite aligned by the Earth's magnetic field (whose poles can thereby be seen to flip at long intervals). The net magnetization can be destroyed by heating and then cooling (annealing) the material without an external field, however.

As the temperature increases,h thermal oscillation, or entropy, competes with the ferromagnetic tendency for dipoles to align. When the temperature rises beyond a certain point, called the Curie temperature, there is a second-order phase transition and the system can no longer maintain a spontaneous magnetization, although it still responds paramagnetically to an external field. Below that temperature, there is a spontaneous symmetry breaking and random domains form (in the absence of an external field). The Curie temperature itself is a critical point, where the magnetic susceptibility is theoretically infinite and, although there is no net magnetization, domain-like spin correlations fluctuate at all lengthscales.

The study of ferromagnetic phase transitions, especially via the simplified Ising spin model, had an important impact on the development of statistical physics. There, it was first clearly shown that mean field theory approaches failed to predict the correct behavior at the critical point (which was found to fall under a universality class that includes many other systems, such as liquid-gas transitions), and had to be replaced by renormalization group theory.

Unusual ferromagnetism

In 2004, it was reported that a certain allotrope of carbon, carbon nanofoam, exhibited ferromagnetism. The effect dissipates after a few hours at room temperature, but lasts longer at low temperatures. The material is also a semiconductor. It is thought that other similarly-formed materials, such as isoelectronic compounds of boron and nitrogen, may also be ferromagnetic. The alloy ZnZr₂ is also ferromagnetic below 28.5 K.

See also

• Paramagnetic

Sources

• Charles Kittel, Introduction to Solid State Physics (Wiley: New York, 1996).
• Neil W. Ashcroft and N. David Mermin, Solid State Physics (Harcourt: Orlando, 1976).
• John David Jackson, Classical Electrodynamics (Wiley: New York, 1999).
• E. P. Wohlfarth, ed., Ferromagnetic Materials (North-Holland, 1980).
• "Nanofoam makes magnetic debut," Physics World 17 (5), 3 (May 2004).
• "Heusler alloy," Encyclopedia Britannica Online, retrieved Jan. 23, 2005.
• F. Heusler, W. Stark, and E. Haupt, Verh. der Phys. Ges. 5, 219 (1903).
• S. Vonsovsky Magnetism of elementary particles (Mir Publishers, Moscow, 1975).

References

1. ^ Richard M. Bozorth, Ferromagnetism, first published 1951, reprinted 1993 by IEEE Press, New York as a "Classic Reissue." ISBN 0-7803-1032-2.