Electron multiplier

  An electron multiplier (continuous dynode electron multiplier) is a vacuum-tube structure that multiplies incident charges. In a process called secondary emission, a single electron can, when bombarded on metal (or PbO coated surface) induce emission of roughly 1 to 3 electrons. If an electric potential is applied between this metal plate and yet another, the emitted electrons will accelerate to the next metal plate and induce secondary emission of still more electrons. This can be repeated a number of times, resulting in a large shower of electrons all collected by a metal anode, all having been triggered by just one. Therefore, another name for electron multipliers is avalanching ion detector. 12 stages of acceleration will usually give a gain in current of 10 million.

Additional recommended knowledge

Better weighing performance in 6 easy steps

Essential Laboratory Skills Guide

Guide to balance cleaning: 8 simple steps

Operation

The avalanche can be triggered by any charged particle hitting the starting electrode with sufficient energy to cause secondary emission. Hence the electron multiplier is often used as an ion detector. It could also be triggered by a photon causing vacuum photoemission of at least one electron. In a photomultiplier tube, a photo-emissive surface is followed by an electron multiplier with several sequential multiplying electrodes called dynodes. Because these electrodes are separate from each other, this might be called a "discrete-dynode" multiplier. A voltage divider chain of resistors is usually used to place each dynode at a potential 100-200v more positive than the previous one.

A "continuous-dynode" structure is feasible if the material of the electrodes has a high resistance, so that the functions of secondary-emission and voltage-division are merged. This is often built as a funnel of glass coated inside with a thin film of semi-conducting material, with negative high voltage applied at the wider input end, and positive voltage near ground applied at the narrower output end. Electrons emitted at any point are accelerated a modest distance down the funnel before impacting the surface, perhaps on the opposite side of the funnel. At the destination end a separate electrode (anode) remains necessary to collect the multiplied electrons. This structure is also known as (single) channel electron multiplier (CEM), and one of the most common is sold under the trade name Channeltron.

Another geometry of continuous-dynode electron mulitplier is called the microchannel plate. It may be considered a 2-dimensional parallel array of very small continuous-dynode electron mulitpliers, built together and powered in parallel too. Each microchannel is generally parallel-walled, not tapered or funnel-like.

Applications

In mass spectrometry electron multipliers are often used as a detector of ions that have been separated by a mass analyzer of some sort. They are typically of the continuous-dynode type, and may have a curved horn-like funnel shape.

See also

• Electron
• Faraday cup
• Daly detector
• Photomultiplier
• Phototube
• Geiger counter
• Scintillation counter
• Lucas cell

Developers

• Zoltán Lajos Bay

References